Please also have a look at the main page about the Chiptronic Resistive Touch Display 7".
When connecting the EDT displays to a Colibri Evaluation Board or an Iris carrier board, make sure that pin 1 of the display is connected to pin 1 of the board.
Due to the nature of the FFC connectors, it is possible to invert the pinout and possibly damage the display and/or carrier board.
- The Chiptronic Resistive Touch Display connectors do have contacts on top and bottom side.
- The Iris Carrier Board also has contacts on top and bottom side of the FFC connector.
- The FFC connector on the Colibri Evaluation Board has only contacts on the side towards the board edge.
Be also careful with the brown levers on the connectors. They are very delicate and can easily break.
Please have a look at the pictures below which show how to connect the cables:
Connecting the Chiptronic Resistive Touch Display 7" to the Colibri Evaluation Board V3.1
Please follow the instructions in the Chiptronic Resistive Touch Diplay 7" - Installation Procedure articles.
Please follow the instructions in the Chiptronic Resistive Touch Diplay 7" (Linux) articles.